Posted by rrlund on July 19, 2018 at 16:38:10 from (69.36.53.168):
In Reply to: Quadrange vs TA posted by Bill VA on July 19, 2018 at 16:26:48:
I had a quad range in the 4040. It didn't free wheel like the 706 IH TA that I had before it did. The shift pattern left a little to be desired. Whenever you shifted from reverse to low,low to high,you had to shift the quad up or down over and over because the vertical movement was at an angle. If you were baling in B4 for example and wanted to back up to spit out a bale,you had to go to B3,B2,B1 then R2. I had something in the neighborhood of 12,000 hours on that one before the dealer had to put a new quad unit in it.
All in all I'd rate it higher than a TA. In all honesty though,I prefer the shift pattern of the Whites with the Over/Under. Six gears with three powershift speeds in each gear and you don't have to go through other gears to get from a forward gear to a reverse.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
