Well rather than GUESS that the voltage is not dropping how about checking it. LOL When the wrap or tie cycle completes the electric actuators make there be an amperage spike when they "hit" the end of their stoke. Just a second or so but a spike. IF you do not have the monitor wired to a heavy enough supply or there is corrosion/bad connection, then you very well could have low voltage when there is a higher amperage demand. The reason the monitor does not show low voltage after being turned off and on is the baler has not placed a demand on the circuit yet. Just as soon as you tie/wrap a bale then there is an amperage demand and the voltage could easily be dropping. Then the monitor tells you about it again.
Your not rebooting a darn computer and everything is all better. Your just resetting the warning system in the monitor. So just MAYBE the monitor is working correctly and telling you that there is a problem.
You need to remember that the Monitor on a JD 66 series balers does not just monitor the baler. It POWERS the electric actuators so it needs more amps available. This is why when a person bought a NEW JD 66 series baler after owning a JD 35 series baler they needed the tractor's wiring harness to be changed to one that can carry a heavier amperage load.
If the voltage is not dropping then you may have to have your monitor repaired. Just send it to Ag Express as they can repair it in an economical fashion.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
