Posted by Geo-TH,In on August 15, 2018 at 14:25:49 from (172.78.60.121):
How often do you have your septic tank pumped?
The wood in the raised flower box over the septic tank was falling apart (second pic). I don't think the tank had been pumped in 20 years. So I decided if I'm going to rebuild the flower box, I should take advantage of nice weather have it pumped.
Only problem was removing the stuck lid. When I tried to lift the lid, the rear tires on my Terramite came up.
I got the sledge out, hit the lid many times while lifting, no luck.
So I punched a hole at one end of lid. Used a 1 inch metal rod. Put it through the hole. Attached the chain to the backside of bucket so I was pulling closer to the front wheels. Lifted the lid again and again the rear wheels came off the ground. About 5 seconds later the wheels returned to the ground, lid broke and it came off. I WON!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.