Posted by Bob on August 16, 2018 at 14:52:21 from (64.255.159.199):
In Reply to: JD 6300 hydraulics posted by CBBC on August 16, 2018 at 11:13:14:
Is the attachment valve set "closed center" to match the tractor, if NOT, there's going to be a LOT more oil pumping and heating.
The "piston" and "gear" on the adjustment knob affect how the lever detent works, The "piston" represents a hydraulic cylinder, for which the valve lever would "kick out" at the end of the cylinder's stroke, the "gear" represents a hydraulic motor.
If the lever is not "kicking out", where you have it set, that part is OK, otherwise try the outer setting.
As to the hoses popping out, either the hoses are tugging on them under certain conditions, or the male tips are worn where the retaining balls "grab", AND/OR, the $$$ Euro-made coupler barrels are worn out, NOT uncommon, unfortunately.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
