Posted by Jim.ME on August 18, 2018 at 14:27:21 from (74.65.186.86):
In Reply to: Micrometer use posted by Bkpigs on August 18, 2018 at 12:32:31:
Your mic set looks good. Often some of the anvils or standards are missing.
The knurled collar on the right is to lock the spindle to hold a measurement, as someone said. Also as posted, the ratchet (knob) at the end is supposed to slip to give a consistent pressure so the readings are right. They are not fool proof and can slip early or hang up but help until one gets the feel of taking a reading. Many micrometers don't have them and many machinists won't use them even if the mic has one.
There should (and needs to be) be a nut at the extreme left to hold the anvils tight in the frame. Maybe it is there but it doesn't look like it, to me, in your photo. They use the same nut, often round with a knurled outer surface, with all four anvils. You calibrate each anvil to the proper standard (rods in the center) using the adjusting nuts on the inner side of the anvils, locking it with the outer nut before checking with the standard. If that nut is missing you might have trouble finding one, as the threads on the anvils may not be a pitch you find in a hardware store. Some of the B&S 55's had a set screw in the side of the frame where the anvil goes in and there will be a flat spot on the anvil that should line up with it when inserted. That should be just tight enough to keep the anvil from rotating when tightening the outer nut, and will not take the place of the outer nut. Originally there would have been a wrench or two to fit the adjusting nuts as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.