Posted by FarmKid61 on August 24, 2018 at 19:00:51 from (66.61.88.102):
Quoting Removed, click Modern View to see
It's been a few months, we've had a chance to check a few things. Here is new status.
1) We confirmed the pump is turning by viewing through the site cover.
2) We pulled the cover held by 3 small screws to try to free up the metering valve etc. Not sure where the valve and connections are in there, but couldn't diagnose anything sticking and everything seemed free.
3) After putting back together we tried again to start. We were getting diesel fuel leaking from 1st 2 cylinder injector boots, so we replaced all four boots. No leaks now.
4) Still no diesel fuel coming from the injector lines that we loosened when we started working on this.
5) Does anyone have a picture or diagram of the metering valve and plungers so we can be sure they are not stuck?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
