Posted by used red mn on August 31, 2018 at 23:02:47 from (75.73.112.20):
In Reply to: Re: engine rebuilding? posted by jimg.allentown on August 31, 2018 at 12:26:33:
Yep agreed, rod or main crankshaft bearing journals are finish ground to a certain diameter spec. For EXAMPLE say your engine has a specified rod bearing journal of 2.000 inches it wears down below the allowed tolerance and needs resized. So a machine called a crankshaft grinder is used to very precisely grind the journal down 0.010” undersize. So now the bearing insert halves needed are 0.005 inches thicker to fit the smaller diameter journal. So they would now fit the new small diameter rod journal that is 1.090 inches. That ...undersize... diameter is how normal machinists nomenclature or naming would refer to them. I agree with finding someone to mentor you through this process there are a lot of steps that need performed properly during and engine rebuild to ensure longevity.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
