Posted by showcrop on September 01, 2018 at 13:30:44 from (75.68.37.174):
In Reply to: engine rebuilding? posted by jl ray on August 31, 2018 at 10:27:35:
jl ray, some of these guys are making this way more complicated than it really is. What actually happens is you ask around about who runs a good automotive machine shop. Then you give them a call and tell them what you are doing and they will give you an idea what it will cost. Then you drop your short block and head to if you wish off with them. You will go over with them what services you want and don't want. They will give you an idea of when it will be ready and THEY WILL ASK YOU "DO YOU WANT US TO GET YOU THE NEW PISTONS, BEARINGS, RINGS" you have a little more discussion and say "YES". This insures that the bearings match the crank as it ends up being ground, and that your pistons and rings will be just right for the bores. There is no way of knowing exactly what the final bore will be or how much the crank needs to be ground until it is done. THIS IS WHAT THESE GUYS DO, not me, not you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
