Posted by tomturkey on September 04, 2018 at 14:51:28 from (64.250.43.70):
In Reply to: Pole barn poles rotted posted by FarmerBlair on September 04, 2018 at 14:05:40:
Farmerblair; go ahead and place the concrete for the floor. But box out or put forms around each existing pole. After the floor has cured remove forms at each post. Place a 4x4 or 6x6 short post on each side of your old post, supported by the new concrete floor, then nail or screw or bolt a 2x8 across all three. This will support your post when you cut off the bottom of the old post. Using the new concrete floor as a guide, you can cut off the old post. Dig out the old rotten portion of the post. How you end up securing the post to the new concrete you will place at each pole is a decision you can make. Using post support anchors someone else mentioned, or bolting angle irons to your post then attaching anchor bolts. Drill some one half inch holes into your new concrete floor, put some rebar dowels in and put in the concrete. Concrete beneath the pole should be 8-12 inches thick, tapered down from your new concrete floor. This method allows you to take on the replacement of one pole at a time as time and money permit, without allowing the roof to sag. We would probably all be surprised by how many pole barns have rotten timber poles just down below the floor/ground level. good luck with your project. gobble
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
