Posted by rossow (mn) on September 15, 2018 at 10:28:39 from (69.24.172.182):
Advice needed: I have an upstairs room in my attached garage. It measures 20x12 with an 8-foot ceiling (angled up from a 3-foot kneewall. The room is heavily insulated (12" ceiling, 8" walls, 8" floor). I'm thinking of heating the room for occasional winter-workshop use a few hours at a time. I'll need to bring the room temp up from an unheated temp often around 0 F. to a tolerable 55 F. or thereabouts. My two options are a wall-vented LP heater or a 220V electric heater. The LP heater would cost $1,200 to $1,800 installed by my regular propane supplier; it would always be on with a standing pilot. An electric heater I can wire and install myself for less than $500. I know electric heat in my area (southern Minnesota) isn't as cheap as LP per hour of use, but the initial price difference is pretty severe. I'd like LP, but that installation price is causing me pause. Which way would you go for occasional, not necessarily constant, heat? Any personal experience with this type of application? All advice appreciated.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
