Posted by CBBC on September 16, 2018 at 09:14:09 from (24.69.117.186):
In Reply to: cut or not cut posted by JML755 on September 16, 2018 at 06:32:04:
I had a 30" x 60' cotton wood about 30' from my packing shed... it was actually taller with all the branches. It probably would have been fine for another 10-20 years but by that point it would have been a monster and it would have taken the primary power down if it went north and my packingshed/ store if it went south.
We took it down without too much trouble. Put a cable on it half way up and pulled with the excavator as it was cut to stop it from swinging into the building.
It was march so there was lots of water in the trunk. When I picked up the trunk to lay on my truck it was like a fire hose of water coming out the bottom.
We let the logs "dry" in the shade for 6 or 7 months and then milled into 2" slabs. They were still plenty wet. I then brought them inside my barn loft and stickered them for another 6 months, actually not the best place as there was little air movement... but they dried out some.
My buddy took them to his wood shop to make a table. He planned them once to open up the surface then stickered them again in a warm room with a dehumidifier. He said he took out a gallon of water a day for the first week and then it was every other day for a couple more weeks... they were probably in that drying room for a couple months before he worked with them. He also had them stacked and stickered with 800lbs of Maple above to keep them from warping.
When he planned them again the were so tough from the inter woven fivers his big planner nearly stalled. It was a little bit at a time.
Here are the pictures before it was finished. I'll try to dig up the completed table later.
Cut it down, I really like the look of it but more trees will grow... and in reality cottonwoods are messy. Great as a shade tree it's the edge of a field.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.