Posted by Hay maker2 on September 19, 2018 at 13:49:39 from (24.39.246.162):
In Reply to: Tariff War Question ... posted by Crazy Horse on September 19, 2018 at 07:45:37:
The days of Henry Ford assembly lines are done. Its all lean manufacturing and only build what you need. Yes in the short term (3-6 months) it cost more on certain machines and setups, but in the long term (1-2 years) it saves the business a lot more than it lost on the short term side.
The comment that if the manufacturing industries come back that the laborers on the floor will be a smaller part. I disagree with this as I have seen this system more times than I can count.
Example:
Yes there will be less welders as there will be more automated production lines (robots). These welders usually turn into to set up operators as they still need people to set up and run these machines. They will need programmers to program the automated lines. And they will need different types of maintenance professionals to maintain these new machines.
There will be about the same amount of jobs, just in different areas than they were 50 years ago. 50 years ago you never heard of an IT department, now everyone has one. There were no software programmers and now its a must. Times change and so doesn't the job description, the work will be there if the people choose to work and educate themselves.
50 years ago you did not have robot milkers and now there are a lot of them out there. There are also high tech service guys out there to repair them instead of milking a cow.
Yes we will always need welders, fitters, electricians, plumbers, etc., but there are many new jobs that were no where's 50 years ago that we have now.
Automated lines (robots) don't take lunches or breaks, don't take a 20 minute poop right before lunch, they don't stop and BS with their buddy's, and by all means they are not commenting on internet forms like I am right now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.