Before catalytic cracking became widespread they heated and distilled crude to get the different fractions: gasoline, kerosene, diesel etc. The type of crude made a significant difference as to the percentages yielded. A barrel of oil would yield "X" amount of several fractions. My understanding is that distillate fuels were kind of a leftover and thus sold at a low price. Too heavy to vaporize for starting, they worked by being vaporized by specially designed "Hot" manifolds and run while the engine was thoroughly warmed up. Lower compression ratios had to be used to prevent spark knock. Distillate did have more BTU than gasoline.
During WW2 catalytic cracking became widespread so we could turn a whole barrel of crude into gasoline. Refineries had more precise control over what came out and that resulted in fewer orphaned products. During the 50's distillate became less popular and faded from use.
I've heard of diesel being tried in tractors that had all the distillate equipment intact: Hot manifold, distillate tuned carb and radiator shutters. Kerosene or jet fuel would probably be a better try due to being a bit lighter than diesel. Of course kerosene has gotten stupid expensive. Jet fuel is not any better unless you can find some they need to get rid of such as has been de-fueled for maintenance or other reasons.
I've wanted to try jet fuel in an H or an M farmall but haven't gotten to it. Still haven't found radiator shutters for an M that were remotely usable. I have all the components for an H but will have to find one with the low compression pistons or build one just for it. ($$$) I have several Farmalls that were distillate tractors when brand new but over time they were upgraded to higher compression pistons and/or gasoline head to be more efficient on gasoline. The manifolds lived a hard life with all that heat and were nearly all replaced with gasoline manifolds.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.