Neighbor had a mint 63 Impala it was his wife's pride and joy.
Shortly after installing a fresh built engine at an idle there was a faint knock coming from it.
After checking everything he could think of he pulled the engine and took it back to the machine shop that built it.
They went right through it, he put it back in and same knock.
Changed the fuel pump and knock was gone.
Bought a mid 80's Ford 1-ton dirt cheap as the seller said the engine was seized.
Started to take it apart, tried to bar over the engine to get to the converter bolts, one way and it would not budge, tried the other way and it moved followed by klink noise.
Turned out the drive gear from the starter had broke in two and a piece of it was wedged between the ring gear and bell housing.
A customer that I did maintenance for on a fleet of tow trucks called the shop one day and asked me to order in a starter for his truck, he was super busy that day and the starter on his was crapping out and just barely got his engine started.
A few hours later he pulled up at the shop door and honked his horn, we opened the door and he drove onto the hoist, swapped out the starter, he hopped in and turned the key, click, click, click I asked him if he wanted us to check his battery and charging system.
A few foul words from him later and he was on his way with a new battery (and starter).
Another customer paid to have his F 150 towed to the shop from 2 hours away when it arrived I showed him how to reset the inertia switch on his truck, he had backed up to a loading dock and set it off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.