Posted by psimmer on October 04, 2018 at 17:32:22 from (47.35.100.204):
Looking at a 1992 Kubota L2650 with a Sims cab on it. The tractor appears to have been stored inside, is in good shape, steering, brakes, hydraulics, all work well. It has around 1300 hours on it. Everything seemed to work great. Would be used primarily for snowblowing, has a front mount blower as well as a loader. Last winter was miserable for snow, and using a walk behind is becoming way too much of a chore. Anyone familiar with this tractor, how does it start in cold temperatures? I know it has glow plugs, and currently doesn't have a block heater. It would be outside exposed to northern Michigan temperatures. Also, anyone use a Sims cab? Has a metal frame, glass windshield, but canvas doors. No heater inside. Do the windows fog bad? I grew up on open station tractors with heat housers on them, so this cab seems like it would be a step up from that. I do wonder if heat houser type side panels could be put on to somewhat funnel the engine heat back, but not sure if or how any engine heat could or would enter the cab? Are they sealed tight in the front? When I looked at the tractor, I didn't pay any attention to see if that was possible. Thanks in advance.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
