Posted by Wheat47 on October 05, 2018 at 16:49:09 from (63.153.15.252):
In Reply to: Kuboto diesels posted by Tom RS on October 05, 2018 at 15:39:12:
I've worked on Kubota's off and on for many years. Great tough machines. As far as I know, very reliable engines. I have B2710 tractor with loader. It's my "hired hand, helper". Small enough to get in tight spots, but strong enough to lift and hold things until I get a stand under them. Just make sure the PTO turns the proper direction, but I think it was the B6000 that had the backwards PTO. There were special PTO implements made for that tractor. Only thing hard for me is servicing it. As I've advanced in years(Old, 71), it's harder to get down on the ground to work on it.....OK, easy to get down, hard to stand up! So I have a car trailer than I use when it's time to work on the tractor. I run the tractor up on the trailer near the edge of the bed. Then I can stand beside it or sit in the edge of the bed to work on it. Just keep it serviced and I think you'll be fine. Got any other questions, e-mail or message me Jon K
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
