Posted by Janicholson on October 09, 2018 at 18:15:43 from (71.37.1.198):
In Reply to: Re: A paltry thing. posted by Crazy Horse on October 09, 2018 at 15:40:44:
put the end loop on the left end "horn". Hold the board about the middle end to end and toward what is the bottom in the picture. Wrap a loop of string toward you and in the opposite notch. Come up the back side and cross over (important) to the front (toward you) at mid board. wrap across the front of the starting horn in that notch and down the back side. cross over to the front at the mid point and repeat from the second sentence. The effect (topologically) is to wind on the same stick one wrap from one end then one from the other. thus keeping the twist normal in the string. If you ever wrap up an extension cord, the loose end keeps turning over and over. If you wrap up a hose, the nozzle keeps flipping. The way to apply this principle to an extension cord, is to take it off your arm (hand and elbow) every 5 wraps, and turn the wrapped cord around on your arm and wind the other way. Jim
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
