Posted by Oliver550Dave on October 10, 2018 at 19:13:21 from (74.206.93.15):
I posted this a few days ago on Implement Alley with minimal response, so posting here with hopes for more responses!
Any hay rake bone yards out there? I put together 2 JD 350 3ph, pto hayrakes about 25 years ago. The pulley assembly at the rake end of the PTO shaft was in pieces on one rake, and that part from the other rake needed repairs then and later. It is cast iron and I've had it repaired 2 or 3 times since, and it has now seen it's far better days - bearings are not just shot, they're gone! Any suggestions on finding a decent one off another rake? Or should I explore having the local machine shop fabricate a replacement. The one on the JD 350 rake parts diagram doesn't seem to look like the one I have - instead of what looks in the parts list illustration like bolts through a bottom flange, the attaching/tightening bolts for the assembly I have go through the side of its frame and through the front horizontal brace for the rake.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
