Posted by paul on October 12, 2018 at 02:45:47 from (66.60.223.229):
In Reply to: Crop storage posted by DeltaRed on October 11, 2018 at 19:50:19:
Back in the 1940s a good tough fiber was something special, and hemp fibers were quite a deal to develop, it would have been big.
Today a whole lot of synthetic fibers can be blended into nearly and fiber one needs, stronger, rot proof, abrasion resistant, non absorbent, all types of properties. There is far less -need- for natural fibers on an industrial scale.
Lots of milenials have gotten on the ‘we need hemp to save the family farm’ bandwagon, without understanding the laws of supply and demand and how time and technology has moved on.
Ultimately, the demand for the fiber will never get very big, so it will be a small deal.
It’s fine, any few 100 or thousand acres of alternative crop is indeed an alternative.
The biggest market appears to be making tee shirts of the fibers (by beating the natural toughness out of them, ironically) with a pot leaf logo screened on it?
Really in the big picture, I’m not sure such ‘demand’ is going to turn agriculture around.
Jerusilum artichoke and emus might make a comeback sooner!
The window of opportunity for it to be a big deal came and went as the synthetic fibers have been developed.
It will be a nitche, but it won’t be the big deal you hear.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
