3 X on this very important venting to begin on lowest possible point in roof system to highest possible best being the ridge. Adding venting in between will short circuit causing dead spots in the air flow. The usable space of your building should be a sealed box with the roof system just a cap. The goal is to get the attic as close to outside conditions as possible, and still shed the elements. I have vented many roofs and replaced many due to unvented or sealed systems. I've seen where short circuiting air flow can cause additional condensation from heat loss or overheating.
I used countinous ridge venting wherever possible, usually go from roof end to end just because it looks better. The are several good brands for shingle over ridge vents and I prefer the mesh types and never had issue with plugging,and vent the soffits countinously wherever possible.
I don't encourage venting usable space to the roof but exhaust directly outside.
Many years of 3 tab shingle install that have had very good life if installed correctly and good ventilation was in place. Shingles installed in cold conditions and not having good heat and sun directly after tend not to seal as well.
I also used the rafter vents that D beatty pictured all the time and never regretted it.
I roofed a neighbors house 32 years ago with 25 year IKO 3 tab shingles following these practices replacing rotted roof boards, resheathing. They look like they could easily do another 10 years, best part is that they are still happy with job and still a great neighbor.
These are practices I've used with very good results for many years. Good Luck and happy building!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
