Gee, the town hall clerk gave me a zerox copy of the zoning regulations about height, distance from road and property lines, contractor bought the permit and my concrete floor was poured, building put up, not sure when the inspector signed off on it, I did all the wiring, hired an electrician to connect the service panel in the shop to the one in the house. My 24x36 shop with concrete floor cost $11,000 in 1995. Best thing I did was insulate it and put a ceiling in it with 6 inches of insulation above it. I used to use 10 gallons of kerosene a weekend to keep it warm. Now about 10 gallons a winter. Stays cooler in summer too. I did have to get 8 ton of crushed rock to fill in the ditch so dump trucks and ready-mix trucks could back in from the road and stay off my concrete driveway. After shop was done I scooped it up and rocked the path from the existing concrete drive to the roll-up door.
Two pieces of advice. First is Build it BIGGER! Second is put plenty of electrical outlets in, including 240V outlets for tools/equipment you don't own yet.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
