Posted by oldtanker on October 28, 2018 at 18:37:40 from (66.228.255.59):
In Reply to: political talk posted by g ostby on October 28, 2018 at 12:40:04:
Guys I will point out that if you follow the YT think for tractor talk of "A general discussion group focusing on any theme related to tractors" You may as well only read this page about once a week. Won't be any prayer request, post about just crops or livestock, what car/truck to buy or how to fix said car or truck either, washers dryers or other appliances. Nothing about home repair or fixing the barn either. So you would have enough new posts to check it once a week or so to take the needed 5 minutes or so to read everything new.
Get over yourselves. Most of us live in a country where we in most cases are allowed to speak our minds. I know darn well that folks who are not open minded enough to have a conversation are the folks a lot of us tend to avoid in everyday life.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
