Yep, got 2 mom and pop lumber yards in the area. They charge double for a 2X4 stud what either Menards or Home Depot charges. So if I need only one? Yea local is it. More than one? Pays to drive the 25 miles. But Menards, Home Depot and Walmart proved that our business owning neighbors were robbing us blind for years. Many years AFTER the box stores moved in they are still in business too. Even after reducing their prices.....many in our area by about 15%. Yup, friends and neighbors........fellow church members robbed us blind for years.
As far as those dumb city folks? Most of em are not drawing welfare. Percentage wise there are just as many living in rural areas on assistance as in the big cities. The majority make too much money. Heck lot of em make way more than you do ACG. And only do 40-60 hours a week, have good bennies and a nice retirement plan. And most farmers get subsidized crop insurance and the backdoor forced purchase of products in mandatory Ethanol and BIO fuel. So before you start whining why don't you take your hand out of my pocket? If I want to purchase products raised or produced by you I will of my own free will. Not cause you got some crooked politician to force it on me so you would vote for them.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
