You're the canary in the coal mine. Low population density areas can only generate so much tax revenue before you kill the goose that lays the golden egg.
Infrastructure costs are rising much faster than what revenue base can keep up with in rural areas. In the "old days", locals in a small district like yours could show up with hammer in hand and build a school themselves. Now everything is specified, insured, bonded, licensed, etc. and it all adds up to more $$$.
Now there are a lot of good reasons for reasons for regulation and insurance and oversight but sometimes I think we've gone a little too overboard.
I have an ancient photo of my Grandfather and Great-Grandfather and a group of other men in front of their church with paint brushes in hand. When the church needed painting or a new roof or anything the men got together and did the work themselves. A church near me has had work done recently and now everything is hired out. It's great to hire professionals but it costs big money to do so. The church is not doing well financially partially as a result of ongoing and upcoming maintenance and *insurance* costs.
Some roads in this area that once featured a "chip seal" type of pavement have been ground back up into gravel roads because the county can not afford to maintain them in paved condition. The cost for materials have gone up tremendously in the last 10 years. People are complaining but also complaining about paying more taxes. They moved out here and built mcmansions and want city convenience but think roads and trash service don't cost anything.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
