One more comment on your situation. I see lots of comments on this site complaining (rightfully) about bad government decisions. I often wonder if the person complaining made any effort to directly influence the situation before it was finalized and announced. Were they on top of the situation and involved enough to know what was in the works? If they wanted to influence the outcome did they make calls to politicians, write letters, rally their friends and neighbors?
My mother lived in a little town and never held office, but she influenced every decision in that town. She did not win every battle, and she made some enemies, but she sure as heil tried, and she never waited until the cow was out of the barn and off the property to complain to people 800 miles away.
We, the citizens, recently stopped a proposed $34 mil new high school in my town. The board tried to sneak it through, but some on the ball local farmers got wind of it and through meetings, petitions and road signs, they got it on the ballot and it was defeated. But, we did not wait until it was too late and complain...it is our government and we made it operate the way we wanted. Government works when it is responsive to the citizens, but the citizens must tell govt what it wants.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
