Posted by 55 50 Ron on November 21, 2018 at 20:02:33 from (216.114.235.202):
In Reply to: Old Iron On The Farm posted by Rusty6 on November 20, 2018 at 07:50:32:
I sure enjoyed the tour. Is the Cockshutt mower the kind that has the rope lift where a rope is running around a drum turned by the tractor PTO and the sickle bar was raised by pulling on the rope and tightening it around the drum?
This past June I sent my 1949 Chevy 3600 (3/4 ton) truck to Louisiana with my oldest grandson. He is the 4th owner. I ran out of energy enough to do any more restoration work to it and he will have much satisfaction continuing that. It is very similar to those GMCs in your tour.
A few comments on the 15-30 (22-36). My Dad's first tractor was a 22-36. The rear steel wheel extensions were factory though instead of home made. Yours look too symmetrical to be home made. Also the PTO was standard rather than optional. The end of the PTO shaft was a very heavy thread and I remember that the front PTO knuckle on the 10 ft JD grain binder had an inner thread to match. Later IHC made an adapter with inner threads to match the tractor shaft and the other end of the adapter was the spline that became the 540 RPM PTO of later vintage.
I would certainly expect that I could visit many old farm sites in North Dakota and find similar machines as you have shown on this tour.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.