Posted by caterpillar guy on November 30, 2018 at 05:32:41 from (47.26.86.124):
In Reply to: Soybean Question posted by NYOlivers on November 29, 2018 at 18:31:41:
We started cutting with dry or close to it 14-15 moisture, then rain and no more cutting. Then it dried some and then froze so we cut at 18-20 moisture put them in the bin with air on them since they have dried some down to 15.8 on the first load coming out then next was 16. Have not got the moisture on the third load yet. We had a few pods that had split open in the field prior to cutting. We got done Friday of Thanksgiving. Last year we cut beans till Pearl Harbor day. Then still had corn to do. This year corn was down to 22 in early Oct. So shelled it with some sprouting on the stalk in the ear. Back to beans I turned the fans on a month ago and they have not been turned off yet rain snow or sun. I will probably shut the one off this week. The other on the beans at about 18 will keep going some more. With about 9-10,000 bushel of those wet beans at that moisture we shipped those 3 loads this week and dropped to previous mentioned moisture so must be gaining some yet. With half of then gone now the rest should dry faster now. That bin will have a full air floor in it when it gets empty also.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
