Posted by ADB-IA on December 01, 2018 at 09:32:04 from (207.177.40.43):
My Deere 6415 with a Standyne DE10 pump is not wanting to fire. A couple days ago I started it and it died like the fuel had jelled. I had additive in the fuel and it should not have been a problem since it was only down in the teens. But I changed the filters since they were a year old and primed the system by running the electric pump. I tried to start and it fired up for just a few seconds then died again. After that I can't get it to fire at all - no smoke, not even trying to fire. I've got fuel to the injection pump but none to the injectors. I suspect the electric shutoff isn't opening. I've checked current at the plug at the rear of the pump and I get 8.8 volts from the yellow wire to frame ground, but 0 when crossing between terminals of the plug. Is the green wire supposed to be a ground? I get no continuity between green wire and frame ground. I don't want to damage the ECU so I'm asking advice before I do much more testing. Thanks for any help.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
