Tractor Talk Discussion Board |
Re: Re: Re: snow removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on July 26, 2001 at 09:39:25 from (199.3.9.7):
In Reply to: Re: Re: snow removal posted by Dean on July 25, 2001 at 10:12:46:
On the prairies of Minnesota, when we blade snow or stack it with a loader, it makes ridges. When the wind blows, that fills in a little higher than the ridges. So, push it off to the side, higher. And it fills in again, higher.... It's not uncommon to see 8' piles of snow along both sides of a driveway here, while the feilds a 100 feet away just has 6-12" of snow. A blower either blows the snow in the direction I aim, or it blows it up into the air & the wind takes it away. Either way, the snow is away from the driveway, and the ridges don't get more than 2 feet or so, much better than the 8' people with loaders get. For me, if the wind takes the snow, terrific! I don't care where it goes, just away from the driveway. Some of my best snow removal is to wait a day after a SE wind that piles 3 feet of snow on the driveway. We usually get a strong NW wind the following day, & it scours the driveway down to the frozen ice again - as long as I don't have those 8' high banks on each side! :) Obviously, conditions are different for us, and I certainly don't mean to put down your comments. Just different points of view on how things work for local conditions. :) --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|