Posted by 2510Paul on December 16, 2018 at 08:05:50 from (173.202.140.238):
Well, many of you may think I am stupid, but I had not cleaned our dryer vent piping since we build the house in 1979. The pipe is 6-7 ft long, steel or aluminum, and one 90 degree bend so I always figured the lint would just blow out. Wrong! And yes, I have heard before one should clean the dryer venting.
This week we also replaced our dryer. I could not believe how much lint had accumulated to the inside circumference of the dryer pipe. The opening was down to about the size of 1-2 garden hoses. I recently had brain surgery up through my sinuses so as to not get any dust in there I had the neighbor clean it. He was amazed also.
So, check you're dryer vent if you haven't for a while.
I reported earlier we bought an LG washer, my wife loves it. (The Maytag Neptune had bearing failure.) Less water, less soap, less time, less noise, clean clothes, more capacity. Well, as luck would have it the dryer started having issues and now that we had a bigger washer the dryer could not handle a full load. Obviouly I can say nothing about reliability other than what Consumer Reports put out. LG products were at the top of the list. Just information.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.