Posted by JD Seller on December 17, 2018 at 17:38:36 from (208.126.198.213):
In Reply to: Shipping container posted by GEO-TH, In on December 17, 2018 at 07:36:23:
George In have been think hard about using two HI cube shipping containers with trusses across them for additional storage. I would buy the cheaper ones with damaged or missing doors. Then install over head doors instead of the swing doors. Then put a wall on the back of the center section with the front open. I could store mowers smaller tractors in the containers and anything in the center section. I am looking at 48 foot containers set 31 feet apart. So you use a 32 foot truss and rafter the section over the container. The back wall would be concrete peers with regular wood structure on top of them. The total cost is under $13K. I would end up with a building 48 ft. long and 47 ft. wide. The peers are actually floor beams for hog barns. They are 12"x12"x 10'. I would set the containers on the same peers. This would make the center section be about 9 ft. to the square.
The picture I found that looks like it has the containers setting flat on the ground. What am talking about would have the containers setting higher. I would make gravel ramps up to the doors. What I like is the container sections would be pretty secure. The center section would work well to park my gooseneck trailers under.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.