Tractor Talk Discussion Board |
Re: Re: Re: Fence question.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil in MS on August 02, 2001 at 06:19:59 from (207.203.128.11):
In Reply to: Re: Re: Fence question. posted by Kermit on August 02, 2001 at 04:40:58:
I have 110AC Mark V Parmak fencers and they seem very good! First, are you putting ALL of your hay in one location? I did this until I had an electric fence fire and it burned 2/3 of my hay one fall! The fencer was a weed burner though and not a low impedance fencer! Due to the length of the fence it seems that you may have all your hay in one spot! If so I strongly encourage you to consider at least two if not three possible hay lots for protection from fire or lightning! If your hay lot is near a public road then a fire from a discarded cigarette is not that unlikely! Also fireworks and just plain vandalizing is possible! Second. A good four strand barb wire fence built well should protect your hay from hungry cattle as long as you do not place any hay within, say a tractor's width from the fence! If you place the hay too close to a non-electric fence and the cattle get hungry they may push through a good fence! Third. Batteries do go down and if you build a single or even two strand electric fence and have several cloudy days and the battery is kinda old to begin with, you could find the cows in the hay when you get home! Whatever you use if you let them get into the hay a couple or three times in the winter they will be very hard to keep out unless you beef up the fence! I do have electic fences now and like electric in its place! Still not knowing your size or layout, I would vote for a barb wire fence from 4 to 6 strands on your 150 yard strech! Good luck! Phil in MS.
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|