Tractor Talk Discussion Board |
Re: Throttle Setting
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on August 06, 2001 at 12:36:54 from (199.3.9.7):
In Reply to: Throttle Setting posted by Ted Webb on August 05, 2001 at 21:14:58:
This is not an issue with gas engines, and less of an issue with newer computer controlled diesels, so any comparision to a car doesn't really help. A diesel tractor is built to pull & work hard, and best efficiency, power, and wear is achieved on a diesel tractor by loading it up to most of it's work load & runnig at near full rated rpm's. Runnig them too slowly, or worse, runnig slowly & lugging it, is not good. Of course, a lot of diesels pull hayracks, siderakes, have loaders, etc. In those cases, obviosly you don't go barreling along full rpm's all the time..... But if you get it out in the field doing real work, you are better off running about full rated rpm's with a diesel engine, and adjusting your speed with the tranny. Your implements should be matched up to about use most of your pull power at a speed that is comfortable to work at. --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|