Posted by Bob on December 31, 2018 at 20:18:35 from (64.255.159.199):
A few photos of my tractors.
Versatile "G100", Versatile "145", and Deere "8630", taken around 1980. My late uncle Joe is posing with them,
I still have the 8630, and a (different) Versatile "145". Wish I still had the Mopar-powered G100!
8630 playing in the mud, early 80's.
My "424" and "A", and my son Drew.
My "A" at it's previous home, that of a friend, who has since passed away.
Home-made garden tractor, made by my late Uncle Joe, was powered with a CANTANKEROUS old Briggs. Spent a lot of time yanking the rope on that one, "back in the day".
Remains of a little "Cletrac" crawler I wish someone would come and get and restore.
Remains of a "Co-op" tractor that was reversed and had a loader on it when I got it. Wish I had the time and $$$ to rebuild the Chrysler Industrial engine that powers it. Loved hearing those run in the Massey combines.
And, speaking of Massey combines, here's me and my Uncles' Massey "Super 27", probably about 1961 or '62.
My CIH "1494" with Allied loader.
My home made snowblower "tractor", built as a Vo-Ag shop project 1975-'76.
Row of Ollies at a nearby threshing show. (Hawk Museum.)
And, last (for now), a tractor almost as RARE as the "ETD"!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
