Tractor Talk Discussion Board |
Re: Gearing Question relating to a math problem????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jason-Senoia, GA on August 10, 2001 at 21:43:58 from (64.91.166.196):
In Reply to: Gearing Question relating to a math problem???? posted by Alberta Mike on August 07, 2001 at 14:13:01:
Your question reminds me of a friend of mine who used to swear that one Ford truck (short bed) was faster than another Ford truck (long bed). The trucks were identical, other than the difference in wheelbase. In his mind, the difference was directly related to the difference in the length of the driveshafts - the longer driveshaft somehow just could not transmit rotational motion as efficiently as the shorter shaft. All you mountain from molehill builders - don't even start with the greater surface area of the longer shaft creates more theoretical frictional resistance with the air when its turning - this fellow could not even be convinced that unless one shaft was being twisted (distorted), the rotational velocity was equal at both ends of the shaft.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|