Posted by JD Seller on January 02, 2019 at 21:03:19 from (208.126.198.213):
In Reply to: 4440 rear axle posted by Kory1998 on January 02, 2019 at 15:08:34:
The grease your supposed to use is "John Deere Multi-Purpose SD Polyurea Grease TY6341" . JD says this is for the out board axle bearing and all of the MFWD U-joints.
I do know I switched to this grease in my front axle u-joint on my pickup and I have doubled the life of them. Use it in the u-joints of the semi and have not had a u-joint failure in several years.
I also use it any bearing applications I have. Like the grain augers, fertilizer augers. A good friend uses it on his fertilizer carts. He says it is rare now for the bearing to go out on them.
This grease has water and rust inhibitors in it. It also runs before it burns. So in bearings with a little heat and it will flow towards the hot spot.
In is NOT for sliding stuff or even pivot pins. It is not sticky enough to stay in place on them.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
