Tractor Talk Discussion Board |
Re: Adding hydraulics to a Farmall B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLite on August 19, 2001 at 13:22:56 from (209.226.180.188):
In Reply to: Adding hydraulics to a Farmall B posted by Will on August 16, 2001 at 08:25:02:
I don't know how the setup of your tractor is but on my MH I have a side pulley at 700+- rpm and the standard splined rear pto of 540 rpm. My pump is a MH that runs off the front timing gear. There is a hydraulic pump available that runs off the 540 PTO (max 600 rpm) shaft of most tractors. It's a bit pricey and available thru Princess Auto (www.princessauto.com). With american money it would be a good buy. The disadvantage is that mounting on the PTO removes the use of power implements of course. You can rig up a pulley to the pump (or order another style pump) and have it run off the side pulley of the tractor if you have one to keep it out of the way. The pump is 5.7 cu in/rev and 11.4 gpm with a max of 2250 psi for a 1-3/8 in splined shaft. The stock number is 1220035 and goes for $649.99 Can. They make a larger pump at 729.99. All the pumps are shown on page 19 of the catalogue.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|