Tractor Talk Discussion Board |
Re: grease pit construction
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John Ne. on August 21, 2001 at 21:20:19 from (209.74.230.242):
In Reply to: grease pit construction posted by Ted (Oz) on August 21, 2001 at 19:40:15:
Ted, I worked in several old gas stations that had these, grease pit was a good name for them. Three and half to four foot wide, about six or seven feet long, and deep? Well, how tall are you? And do you like to work at arms reach or duck a little? Most were shoulder high to me and I'm six foot. Older pickups were fine, but newer cars felt kinda close. Some had a pair of lights built into the walls. You'll need a floor drain for water. And very necessary is a set of steps, to get in and out. One nice one had a shelf for tools, recessed in the wall. A lot depends on what you'll work on, how long the vehicles are, how wide they are. And last but not least, some way to cover it to keep the dog from falling in, planks usually. Sometimes the cover was recessed below floor level, usually not, as in the shops it was always in use. Hope this helps. John in Nebr.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|