Posted by Destroked 450 on January 20, 2019 at 10:25:38 from (66.38.93.182):
In Reply to: School Bus Chassis posted by modirt on January 19, 2019 at 15:43:01:
No sure about a glider kit on a school bus since the entire body is made by the bus builder and the running chassis is made by a truck mfg.
On big trucks a glider kit is a new frame, cab, hood, radiator, front axle and suspension assembly with no engine or transmission, you can get them with or without rear suspension and axles, can also come with a new sleeper if needed.
Local sawmill I worked at ordered a 16 Peterbilt rolling glider, installed a reman 525 hp Cat, reman 18 spd and reman rear axles.
All reman parts have warranty but not as long as new, engine is a 03 emissions engine so no DEF fluid, no regen or particulate filter.
Using all reman parts they still saved nearly $50K over a new truck and don't have all of the new emissions garbage.
Because of the emissions loophole EPA is trying to outlaw gliders.
Truck and bus frames are rigid in length to support the weights they haul without bowing, they have some side to side flex for traveling on uneven terrain.
For buses once the body is mounted most of the side flex is eliminated.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.