Posted by 1969Ford2000 on January 21, 2019 at 22:32:40 from (73.9.180.167):
I had a big issue with ripping my gravel driveway up pushing snow with my loader bucket. I use a grader blade on the back turned around, and it worked ok but in deep snow it’d just get bogged down. So I came up with a simple design anyone can weld together, works like a champ!! Leaves about 1/4”- 1/2” of snow, but no more torn up driveway.
Here’s what I did- I picked up some 1/4” x2” steel stock, and cut it down to 3 pieces, the bottom section are both about 7” long, top is 5”. I also got some 3/4” round stock and cut it to 2” (width of the 1/4” stock) welded it together so that the top section is set back at an angle, with the round stock between to make a nice gradual curve to it. Other piece of straight steel acts a bit like a clamp, set up the thickness of my bucket. Drilled and tapped some holes, so when it snows I throw them on, bolt the top to clamp it in, and it’s good to go! Super easy project, and now I just get the loader “levelish”, put it on float, turn the back grader around and go to town.
There’s probably something like this on the market, but it probably costs about $500. All in, I’m at probably $40 worth of steel from the hardware store.
Hope it helps someone who’s tired of tearing their driveway up!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Lets make one more addition to our series on hydraulics. Ive noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
