Posted by Determined on January 24, 2019 at 07:20:43 from (216.130.212.201):
In Reply to: Pipe Line update posted by JD Farmer on January 23, 2019 at 13:47:49:
Quoting Removed, click Modern View to see
Just curious reading about the threading problem you experienced.
I am led to believe that once you switched lubricants the problem went away.
Was it believed that the brief surface exposure of the sulfur containing tapping fluid was enough for it to start migrating into the metal and lead to the failure, or was it possibly an issue of the extra lubricity of the high sulfur tapping fluid allowing the operator to be over aggressive when tapping the hole and stressing the surrounding material?
I have worked on tanker trucks that hauled sour crude and am well aware of the embrittlement long term exposure can cause, but I never would have thought such a brief low concentration surface exposure on something the size of what you were working with could have such an impact.
One would think with the amount of sulfur in fuel oil or even some anti seize compounds that are subject to long term exposure they would potentially have a much greater effect on metals.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.