Tractor Talk Discussion Board |
Re: Torquing Head Bolts - do I add anti-seize ????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ferrell freeman on August 29, 2001 at 13:32:55 from (63.26.249.97):
In Reply to: Torquing Head Bolts - do I add anti-seize ???? posted by Alberta Mike on August 29, 2001 at 07:35:06:
What does the manufacture recomend in the repair manual ,if there is no recomened then light coating of oil . Making sure not to over lubercaite . The biggest problem with to much oil you, have the same problem as anti-seize also if to much you oil on a bolt hole that drilled with no exit or almost bottoms out,the oil will form prssure and give you false reading or strip out maybe worse brake it off in the block .Which when someone brings an engine with broke off or stripped out threads 90%of the time oil bet the end of the bolt and the bottom of the hole.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|