Posted by Crazy Horse on January 31, 2019 at 10:14:56 from (75.158.37.1):
In Reply to: Re: No Heat posted by 2510Paul on January 31, 2019 at 07:36:36:
Paul ..... this isn't much help but here it is .... now try to figure out what it means is another thing !!!
Watch for Trane Furnace Error Codes that Flash Multiple Times The great thing about having a Trane furnace is that there are error codes that will blink in sequence to let you know what’s wrong with your system, and once you know these codes, you’ll easily be able to schedule repairs. Watch out for these sequence of flashes:
Two flashes means that there has been a system lockout Three flashes indicates a draft pressure error Four flashes and your furnace is experiencing an open temperature limit circuit issue If you see five flashes, a flame was sensed within your furnace that should not be present The six flash error code means that your AC power was reversed or the voltage was too low Seven flashes indicates a problem with your gas circuit A low flame is indicated by eight flashes Check your igniter circuit if you see nine flashes
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
