Tractor Talk Discussion Board |
Re: Using left-handed drill bits - A QUESTION ????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert in W. Mi. on September 03, 2001 at 15:55:20 from (204.157.28.53):
In Reply to: Using left-handed drill bits - A QUESTION ???? posted by Alberta Mike on September 03, 2001 at 07:26:20:
Mike, The way you keep from welding the stud to the head is to drop a good size thick washer over the protrudeing stud and weld it on first. Then center a big nut on the washer and weld it on!! If this doesn't work, i'd not buy all the sizes of L hand bits. I'd drill most of the holes with R. hand, and then switch to L. Soaking with Blaster, or Liquid Whench for a few days before you start drilling will help a lot too!! Robert
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|