Tractor Talk Discussion Board |
Re: Re: Loader removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ted on September 03, 2001 at 23:07:34 from (64.5.66.170):
In Reply to: Re: Loader removal posted by Jordan(OH) on September 01, 2001 at 04:27:05:
I believe you got it right except for one thing, if your loader is simmilar to our MF. After lifting the lever, you have to back the tractor up and let the loader slide ahead. There are wedge blocks in the bottom frame that holdes the loader down. If it doesn't slide ahead, just take a prybar and pry it ahead, it should move easily, it helps when the tractor can roll back too (out of gear and brake off--assuming you are on level ground) Once out just raise the bucket which will spin the frame around and it will support the bucket. You don't need to drop the loader where you something to push against like they say in the book. It will come off easily. The only trick is that when you put it back on it may not slide in far enough to let the catches on the lever trip. This isn't a problem, just lift up the loader (the wedge blocks will catch) and move it to somewhere where you don't mind tearing up the grass or lane and let the loader down and pop the clutch a few times and the latches will catch. The MF's have a good loader that is very tough and is easy to remove. If you do a lot of heavy lifting, here is a suggestion. Weld a piece of channel iron over the hyd. lines on the cross piece at the front of the loader. This way you can wrap a chain around the frame and then over the bucket for lifting heavy objects. Another suggestion is to loosly bolt a chain hook to one side of the loader(ours had a small hole in the upper corner of the side) this makes it handy to hook chains to move round bales or other things that need to be chained to stay.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|