Posted by Bruce from Can. on February 03, 2019 at 02:48:59 from (74.12.71.182):
In Reply to: snow blower help posted by ralph1111 on February 02, 2019 at 22:44:36:
I have done a lot of snow blowing over the past 40 years, and width and power are considerations. Not sure how many hp your tractor would crank out , but let’s say 40-50 hp. So 6-61/2 foot blower should be ok, provided that your tractor has a slow enough ground speed , while in reverse, at full throttle. You want the snow blower to be no wider than the tractor. So if your Allis tractor has the adjustable rear wheels, I would narrow the tires in as much as possible. Then measure the tractors total width, and get a blower that wide. Older tractors often only had one reverse gear, and if the snow is more than 4-6 inches deep, or drifted 1-2 feet deep, you will be constantly be on the clutch. But your Allis tractor is well suited for this with your hand clutch. Hope some of this helps.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
