Posted by Roger Tomfohrde on February 05, 2019 at 15:30:10 from (167.177.39.8):
In Reply to: Gas line measurement posted by 2510Paul on February 05, 2019 at 09:06:25:
OK tell me if I am correct. The 1/2 inch line comes from the meter 68 feet to the manifold by the furnace where there is a pressure regulator. If I am correct there could be 2 psi to the regulator by the furnace and then drop down to 16 inches or a tad less for the equipment serviced by the regulator. Most furnace gas valves will lock out over 16. Two psi on 1/2 inch line is good for 290 k btu on 60 feet..Even so the line should have been up sized. Two things I see in your pictures, One is there is no grounding conductor on the line(Lightning prevention) and yellow csst is not approved for direct burial, they make a product for that. Easiest thing to do here is to get a gauge and check pressure of the line before and after the last regulator which will tell you what you really have. The second thing to do is to clock the meter with a watch and see how many units you are using. There is you tube videos on how to do it and my book is 40 miles away right now. I used to carry fittings to be able to do this. The best story I have is some one changed a gas line on a furnace and then said our piping was too small. Well I found they had a flap of plastic on the inlet of the black iron elbow still there blocking the flow of gas.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.