Posted by gotmyfarm! on February 05, 2019 at 17:18:55 from (184.100.95.119):
In Reply to: snowblower carb posted by gotmyfarm! on February 05, 2019 at 12:01:02:
I think I have the throttle good now. The moving part that the metal rod goes to on top of the unit I took off, when hooked back up would not spring back to the position I assumed is the off position when I pushed the throttle lever down to stop position. The round "door" in the unit wasn't closing. I haven't found any info on this, so correct me if I'm wrong. Adjusted the spring screw behind the throttle lever and the governor arm back where rods hook to, and it goes back to the off/closed position now. I know people usually adjust after they start it and when they see if it's running too fast or slow or rich or poor or whatever. I just think I could see it was way off before even starting it and was afraid that if it did start, it wouldn't shut off if I left it like that. So, I did try to start it then after I got it adjusted, in the dark, in the storm, and it didn't start. I don't know... I did the whole list recommended here and am sure that was needed. Lots of crud was in there and now I know that float needle seals and it's not leaking like it was. could it be spark plug? Or, I did have the throttle all the way up. I think it supposed to be half for starting? Had choke off then put on, then put back off. Maybe I did too much trying to start it. Will try again tomorrow after it is rested.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
