Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: changing oil brands
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on September 06, 2001 at 12:18:36 from (128.242.4.59):
In Reply to: Re: Re: Re: Re: changing oil brands posted by Ted (Oz) on September 06, 2001 at 03:31:41:
Well I hope I don't start a war here. I have been trying to leave name brand oils and specific automakers out of my comments simply to avoid further argument. I am glad I did in my original re-post, otherwise this would be a real expanding portion of your original post. The dealership that I worked for just happened to be Ford, but we worked on other makes of cars becuase the dealership had a used car lot and we worked on a few other makes for our more loyal customers. The worst oil that I found to dirty up an engine after prolonged use was pennsoil. Most other oils didn't seem to be as bad as pennsoil. If I was tearing down an engine that had alot of miles on it and the customer said they always used pennsoil it was a sure bet it was going to be grimmy and guncked up inside. I always hated it becuase all parts would have to be cleaned to a shine before assembling. Spending the better part of a day cleaning parts was not fun. There were some oils that I never run across so it would be hard for me to say which ones would be second, third, and forth runners up but I know it would be hard to get worse than pennsoil. You surely know some engine mechanics, so just ask them and see if they have been paying attention to this. They will probably be able to give you some more simular info if they have been observing this kind of thing. I hope the shooting don't start. Me and Robert have some good discussion above as well as me and you down here. I just hope this don't all explode. If it does I might have to renig on entering future oil discussion. lol I am just glad to help, but not trying to cuase fights, arguments, or wars.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|