Posted by modirt on February 20, 2019 at 10:53:58 from (199.187.163.74):
Quoting Removed, click Modern View to see
Found a similar reference to using a slit pipe on another forum, those were made with pvc or abs schedule 40 plastic pipe.
Found a 5' piece of pvc scrap, so tried it and it worked perfect!!! Just drop the blade and go......no worries at all about digging.
Only problem was the still exposed 1 1/2' on the ends would dig in now and then on uneven ground. Have since upgraded to a new piece that runs the full 8' length.
Skinny is the 2" size pipe works best on average. Smaller in the range of 1 1/2" is more aggressive on a hard surface. Larger works better on soft spongy gravel. The plastic pipes are temp until I can get to the farm where we have a big pile of 2" steel pipe and a cutting torch to cut the slit in it and can weld on some tabs for the end bolts.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
